Freewheel — removal and installation (Aprilia Shiver 750)
- Main
- Aprilia
- Shiver
- SL 750
- Engine and systems
- Engine repair
- Freewheel — removal and instal…
Contents: Removal ↓ Installation ↓
Removal
Heat the magneto flywheel with the specific heater.
Undo and remove the six screws. Remove the freewheel from the magneto flywheel.
Installation
Insert the woodruff key on the crankshaft.
Insert the start-up transmission gear after applying a layer of grease.
Insert the flywheel on the crankshaft.
Screw the screw together with the washer but without tightening.
Place the appropriate tool for locking the flywheel.
Locking the flywheel in position, using the specific tool, tighten the screw on the crankshaft.
Remove the special tool.
Specific tooling: 020713Y Flywheel extractor
Locking torques (N·m):
- Screw fixing Rotor - Crankshaft - M12x1.25 (1) 120 Nm (88.51 lbf·ft)
Place the retention plate.
Tighten the screw.
The original text is on the website: Motoinstruction.ru
See this article in russian language
This article has been reviewed: Serafim Sazonov
Similar articles about motorcycles of other brands
Disassembling and assembling freewheel БМВ F 650 GS (2000-2007)Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Control devices
- Operation manual
- Technical characteristics
- Maintenance
- Engine and systems
- Engine repair
- Lubrication system
- Cooling system
- Fuel system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Electric equipment
- Equipment and devices