Elements of transmission motorcycle Honda CRF1000L Africa Twin (2015-2020)

Service information — clutch/gearshift linkage (CRF000/A)
General This section covers service of the clutch and gearshift linkage. All service can be done with the engine installed in the frame. Engine oil viscosity and level have an effect on clutch disengagement. When the clutch does not disengage or the...

Troubleshooting — clutch/gearshift linkage (CRF1000/A)
Clutch lever is too hard to pull in Damaged, kinked or dirty clutch cable Improperly routed clutch cable Damaged clutch lifter mechanism Faulty clutch lifter bearing Clutch lifter piece installed improperly Clutch slips when accelerating Clutch...

Component location — clutch/gearshift linkage (CRF1000/A)
Component location

Right crankcase cover — removal, installation and inspection
Removal Drain the engine oil (page 3-12). Drain the coolant (page 8-4). Remove the bolts [1] and engine right side rear cover [2]. Loosen the lock nuts [1] and release the clutch cable [2] from the clutch lifter lever [3]. Loosen the hose band...

Clutch — removal, installation and inspection
Removal Remove the right crankcase cover (page 12-4). Loosen the set plate bolts [1] in a crisscross pattern in 2 or 3 steps, and remove the bolts, set plate [2], and clutch springs [3]. Remove the following: Clutch pressure plate [1] Clutch spring...

Primary drive gear — removal, installation, disassembly, inspection and assembly
Removal Remove the following: Cylinder head (page 10-13) Rear balancer (page 14-9) Clutch (page 12-8) Remove the cam chain tensioner pivot bolt [1], cam chain tensioner [2], and washer [3]. Remove the bolts [4], cam chain guide plate [5], and cam...

Gearshift linkage — removal, installation and inspection
Removal Remove the following: Clutch (page 12-8) Gearshift arm (page 12-21) Remove the bolts [1] and gearshift spindle cover [2]. Release the wire clip [3] Clean off any dirt from the gearshift spindle serration [4]. Remove the bolt [1] and set...

Gearshift pedal — removal/installation
Removal/installation Remove the pinch bolt [1] and gearshift arm [2] from the gearshift spindle [3]. Remove the pivot bolt [4] and gearshift pedal [5]. Remove the dust seals [6]. Check the dust seals and tie-rod ball joint dust cover for...