- Fairings (see Frame chapter)
- Fuel Tank (see Fuel System chapter)
- Rear View Mirror Bracket
- Brake Hose Joint Bolt [A] and Bracket Bolt [A]
- Front Wheel (see Wheels/Tires chapter)
- Front Fork (see Suspension chapter)
- Steering Stem Head Nut and Washer
- Steering Stem Head and Handlebars
Pushing up the stem base, and remove the steering stem lock nut [A], steering stem nut [B], stem cap [C], then remove the steering stem ID].
Special Tool - Steering Stem Nut Wrench: 57001-1100
Remove the upper stem bearing inner race.
To remove the bearing outer races [A] pressed into the head pipe [B], insert a bar [C] into the recesses [D] of head pipe, and applying it to both recess alternately hammer it to drive the race out.
Note. If either steering stem bearing is damaged, it is recommended that both the upper and lower bearings (including outer races) should be replaced with new ones.
Remove the lower stem bearing (with its grease seal) which is pressed onto the steering stem with a suitable commercially available bearing puller.