Removal
Remove the wheel, and take out the following.
- Collars
- Coupling (out of rear hub)
- Grease Seals
- Circlips [A]
Special Tool - Inside Circlip Pliers: 57001-143 [B]
Take the bearings [A] out of the hub.
Caution! Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc. Place blocks under the wheel so that the disc does not touch the ground.
Special Tools
Bearing Remover Shaft, ∅13: 57001-1377 [B]
Bearing Remover Head, ∅25x∅28: 57001-1346 [C]
Installation
Before installing the wheel bearings, blow any dirt or foreign particles out of the hub with compressed air to prevent contamination of the bearings.
Replace the bearings with new ones.
Note. Install the bearings so that the marked side faces out.
Press in each right the bearing [A] until they are bottomed.
Special Tool - Bearing Driver Set: 57001-1129 [B]
Replace the circlips with new ones.
Special Tool - Inside Circlip Pliers: 57001-143
Replace the grease seals with new ones.
Press in the grease seals [A] so that the seal surface is flush [B] with the end of the hole.
Apply high temperature grease to the grease seal lips.
Special Tool - Bearing Driver Set: 57001-1129 [C]