Install the pin [B], inner rotor [C] and oil (water) pump shaft [D].
Turn the pump shaft so that the slot [E] in its shaft fits onto the projection [F] of the pump drive gear shaft.
Fit the pin [A] of the oil pump cover [B] into the hole [C] in the crankcase.
Install:
- Pins [A]
- Water Pump Body [B]
- Impeller [A] and Bolt [B]
- Pins [C]
- Water Pump Cover [D]
Torque - Impeller Bolt: 9.8 N·m (1.0 kg·m, 87 in·lb)
Apply a non-permanent locking agent to the threads of the water pump cover bolts, and tighten them.
Torque - Water Pump Cover Bolts: 12 N·m (1.2 kg·m, 104 in·lb)