Cylinder wear (Kawasaki ZX600-J1)

0

Since there is a difference in cylinder wear in different directions, take a side-to-side and a front-to-back measurement at each of the two locations (total of four measurements) shown in the figure.

If any of the cylinder inside diameter measurements exceeds the service limit, replace the cylinder.

• [A] 10 mm
• [B] 60 mm

Cylinder Inside Diameter
Standard: 65.960-65.972 mm
Service Limit: 66.06 mm

See this article in russian language

Article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002): «Cylinder wear»: https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/repair/111313 <a href="https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/repair/111313">Cylinder wear</a> - article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002) from section «Engine repair». [url=https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/repair/111313]Cylinder wear[/url] - article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002) from section «Engine repair».