Removal
Remove the right lower fairing (see Frame chapter).
Slide the dust cover at the clutch cable lower end out of place.
Loosen the nuts, and slide the lower end of the clutch cable to give the cable plenty of play.
Screw in the adjuster.
Line up the slots [A] in the clutch lever, and adjuster [B], and then free the cable from the lever.
Free the clutch inner cable tip from the clutch release lever.
Push the release lever toward the front of the motorcycle and tape the release lever to the clutch cover to prevent the release shaft from falling out.
Pull the clutch cable out of the frame.
Installation
Run the clutch cable correctly (see General Information chapter).
Adjust the clutch cable (see Lever Free Play Adjustment).
Lubrication
Whenever the clutch cable is removed, lubricate the clutch cable as follows.
Apply a thin coating of grease to the cable upper and lower ends.
Lubricate the cable with a penetrating rust inhibitor.
