Clutch plate assembly — adjustment (Kawasaki ZX600-J1)

0

Inspect the clutch plate assembly length, and then replace the steel plate(s) which brings the length within the specified range.

Remove:

• Spring Bolts
• Spring Holders
• Springs
• Spring Plate

Replace the following steel plate(s)

Part No.	Thickness
13089-1126	1.4 mm
13089-013	1.6 mm (STD)
13089-1073	2.0 mm

Note. Do not use the steel plate of 1.4 mm and 2.0 mm thickness at the same time.

Install the removed parts, and inspect the clutch plate assembly length.

Torque - Clutch Spring Bolts: 8.8 N·m (0.90 kg·m, 78 in·lb)

See this article in russian language

Article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002): «Clutch plate assembly — adjustment»: https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/transm/111333 <a href="https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/transm/111333">Clutch plate assembly — adjustment</a> - article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002) from section «Transmission». [url=https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/transm/111333]Clutch plate assembly — adjustment[/url] - article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002) from section «Transmission».