- Remove the right frame cover. (9-5)
- Remove the lower frame cover 1.
- Disconnect the EXCVA lead wire couplers 2.
- Disconnect the front and rear HO2 sensor lead wire couplers. (For E-02, 19, 24)
- Remove the muffler cover 3.
- Remove the No. 1 muffler 4.
- Remove the right frame lower cover 5.
Note: Indicates hook location.
- Remove the exhaust pipes 6 and the No. 2 muffler 7.
Installation
- Install the exhaust pipe and muffler in the reverse order of removal. Play attention to the following points:
- Install the exhaust pipes 1 with the No. 2 muffler 2.
Caution: Replace the gaskets with new ones.
- Tighten the exhaust pipe bolts and No. 2 muffler bolts and nut to the specified torque.
- Exhaust pipe bolt: 23 Nm (2.3 kgf·m, 16.5 lb·ft)
- Muffler mounting bolt and nut: 23 N·m (2.3 kgf·m, 16.5 lb·ft)
- Apply gas sealer to the exhaust pipe connectors.
Exhaust gas sealer: permatex 1372
Caution: Replace the exhaust pipe connector with new ones.
- Install the No. 1 muffler 3.
- Tighten the No. 1 muffler bolts and muffler connecting bolts.
- Muffler mounting bolt: 23 Nm (2.3 kgf·m, 16.5 lb·ft)