Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
1. Locate the left hand brake disc and ABS pulser ring to the wheel as noted during removal.
2. Fit new fixings and tighten to 22 Nm.
3. Fit the other disc in the same way.
4. Refit the front wheel (see Front wheel - installation).
5. Check, and if necessary, adjust the air gap between the wheel speed sensor and the ABS pulser ring (see Front ABS sensor air gap measurement).
6. Check for correct brake operation. Rectify as necessary.
Warning! It is dangerous to operate the motorcycle with defective brakes; you must have your authorised Triumph dealer take remedial action before you attempt to ride the motorcycle again. Failure to take remedial action may reduce braking efficiency leading to loss of motorcycle control and an accident.