2. Connect the engine breather hose and refit the spring hose clip.
3. Connect the secondary air injection hose.
4. Align the front of the air box to the frame and loosely install the front fixing. Do not tighten the fixing at this stage.
5. Align the rear of the airbox to the throttle bodies and fit the airbox intake trumpets, as noted for removal. Tighten the fixings to 6 Nm.
6. Tighten the airbox front fixing to 8 Nm.
1. Airbox intake trumpet fixings; 2. Airbox front fixing
7. Attach the main harness connector to its bracket in the airbox upper section. Connect the multiplug for the immobiliser to the main harness.
8. Fit the air filter element (see Air filter element - installation).
9. Refit the airbox upper section. Ensure that the routing of the immobiliser/TPMS control module harness is as noted for removal. Tighten the fixings to 1.5 Nm.
10. Refit the engine ECM and its bracket to the airbox. Tighten the two fixings to 1.5 Nm.
11. Refit the MAP sensor to the airbox and tighten its fixing to 2.5 Nm.
12. Secure the MAP sensor hose to the airbox.
13. Refit the air temperature sensor and tighten its fixing to 2.5 Nm.
1. Fixings; 2. Air temperature sensor; 3. MAP sensor hose; 4. MAP sensor; 5. Engine ECM
Perform the following operations: