Ambient air pressure sensor — installation (Triumph Street Triple 765 R/RS)

0

Warning!

• Make sure the motorcycle is stabilised and adequately supported.
• A correctly supported motorcycle will help prevent it from falling.
• An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

1. Reconnect the electrical connector to the ambient air pressure sensor.

2. Fit the sensor to the battery tray and tighten its fixing to 1.5 Nm.



Perform the following operations:

• Seat bridge - installation
• Rear panel - installation
• Battery - installation
• Seat - installation

See this article in russian language

Inlet air pressure sensor (service code 12) Kawasaki Vulcan VN 900 (2006-2024)
Ambient Air Temperature Sensor Inspection Suzuki 1000A/XA V-Strom (2014-2019)
Checking the atmospheric pressure sensor Yamaha FZ1 Fazer (2006-2015)
Oil pressure sensor — removal and installation Honda CB 400 SF (1992-1999)
Manifold absolute pressure sensor: MAP — removal and… Harley-Davidson V-Rod (2002-2006)

Article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024): «Ambient air pressure sensor — installation»: https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/fuel/113933 <a href="https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/fuel/113933">Ambient air pressure sensor — installation</a> - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Fuel and control system». [url=https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/fuel/113933]Ambient air pressure sensor — installation[/url] - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Fuel and control system».