Clutch cover — installation (Triumph Street Triple 765 R/RS)

0

Warning!

• Make sure the motorcycle is stabilised and adequately supported.
• A correctly supported motorcycle will help prevent it from falling.
• An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Note: The pull-rod should be free to move in and out and also it should be free to turn.

1. Incorporating a new clutch cover gasket, position the clutch cover to the crankcase.

2. Tighten the clutch cover fixings to 11 Nm in the sequence shown below.

3. Re-tighten the fixings one and two to 11 Nm.



The original text is available on an online resource: MOTOINSTRUCTION

4. Refit the clutch cable to the actuating arm (see Clutch cable - installation).

5. Set the clutch adjustment (see Clutch cable - installation).

Perform the following operations:

• Battery - installation
• Seat - installation

See this article in russian language

Clutch cover Suzuki V-Strom DL-1000K2/K9 (2002-2012)
Removing the clutch cover Yamaha FZ1 Fazer (2006-2015)
Clutch cover — removal and installation Kawasaki ZX6R/ZX600J (2000-2002)
Clutch cover Harley Street 500 (2014-2021)
Removing the gear change lever, the sprocket cover and the… Ducati ST2 (1997-2003)

Article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024): «Clutch cover — installation»: https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/repair/113784 <a href="https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/repair/113784">Clutch cover — installation</a> - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Engine repair». [url=https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/repair/113784]Clutch cover — installation[/url] - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Engine repair».