Electrolyte filling
Make sure that the model name [A] of the electrolyte container matches the model name [B] of the battery. These names must be the same.
- Battery Model Name for VN900B/D: YTX12-BS
Caution! Be sure to use the electrolyte container with the same model name as the battery since the electrolyte volume and specific gravity vary with the battery type. This is to prevent overfilling of the electrolyte, shorting the battery life, and deterioration of the battery performance.
Caution! Do not remove the aluminum sealing sheet [A] from the filler ports [B] until just prior to use. Be sure to use the dedicated electrolyte container for correct electrolyte volume.
Place the battery on a level surface.
Check to see that the sealing sheet has no peeling, tears, or holes in it.
Remove the sealing sheet.
Note. The battery is vacuum sealed. If the sealing sheet has leaked air into the battery, it may require a longer initial charge.
Remove the electrolyte container from the vinyl bag.
Detach the strip of caps [A] from the container and set aside, these will be used later to seal the battery.
Note. Do not pierce or otherwise open the sealed cells [B] of the electrolyte container. Do not attempt to separate individual cells.
Place the electrolyte container upside down with the six sealed cells into the filler ports of the battery. Hold the container level, push down to break the seals of all six cells. You will see air bubbles rising into each cell as the ports fill.
Note. Do not tilt the electrolyte container.
Check the electrolyte flow.
★ If no air bubbles [A] are coming up from the filler ports, or if the container cells have not emptied completely, tap the container [B] a few times.
Keep the container in place for 20 minutes or more. Don't remove the container from the battery until it's empty, the battery requires all the electrolyte from the container for proper operation.
Caution! Removal of the container before it is completely empty can shorten the service life of the battery. Do not remove the electrolyte container until it is completely empty and 20 minutes have elapsed.
Gently remove the container from the battery.
Let the battery sit for 30 minutes prior to charging to allow the electrolyte to permeate into the plates for optimum performance.
Note. Charging the battery immediately after filling can shorten service life. Let the battery sit for at least 30 minutes after filling.
Initial charge
Place the strip [A] of caps loosely over the filler ports.
Newly activated sealed batteries require an initial charge.
- Standard Charge: 1.2A 5-10 hours
★ If using a recommended battery charger, follow the charger's instructions for newly activated sealed battery.
Kawasaki-recommended chargers:
- Optimate III
- Yuasa 1.5 Amp Automatic Charger
- Battery Mate 150-9
★ If the above chargers are not available, use equivalent one.
Note. Charging rates will vary depending on how long the battery has been stored, temperature, and the type of charger used. Let battery sit 30 minutes after initial charge, then check voltage using a voltmeter. If it is not at least 12.8 V, repeat charging cycle.
After charging is completed, press down firmly with both hands to seat the strip of caps [A] into the battery (don't pound or hammer.). When properly installed, the strip of the caps will be level with the top of the battery.
Caution! Once the strip of the caps [A] is installed onto the battery, never remove the caps, nor add water or electrolyte to the battery.
Notes:
- To ensure maximum battery life and customer satisfaction, it is recommended the battery be load tested at three times its amp-hour rating for 15 seconds.
- Re-check voltage and if less than 12.8 V repeat the charging cycle and load test. If still below 12.8 V the battery is defective.