Warning! The ignition system produces extremely high voltage. Do not touch the spark plugs, ignition coils, or spark plug high-tension cables while the engine is running, or you could receive a severe electrical shock.
Caution!
- Do not disconnect the battery cables or any other electrical connections when the ignition switch is on, or while the engine is running. This is to prevent IC igniter damage in the ECU.
- Do not install the battery backwards. The negative side is grounded. This is to prevent damage to the IC igniter in the ECU and the diodes.
Ignition coil removal
Remove:
- Screw [A]
- Ignition Coil Cover [B] (Pull out)
Remove:
- Spark Plug Caps
- Fuel Pump Connector [A]
- Ignition Coil Bracket Bolts [B]
- Primary Leads [C]
- Ignition Coil Mounting Nuts [D]
- Ignition Coils [E]
Ignition coil installation
Connect the primary leads to the ignition coil terminals and run the secondary cables according to the Cable, Wire and Hose Routing section in the Appendix chapter.
- [A] Front Ignition Coil
- [B] Rear Ignition Coil
- [C] Dampers
- [D] Bracket
Install:
- Ignition Coil Cover