Frame and attachments of motorcycle Yamaha FZ1 (2006-2015)

Removing the seat and battery
Order Job/Parts to remove Quantity Remarks 1 Passenger seat 1 2 Rider seat 1 3 Battery band 1 4 Battery cover 1 5 Battery negative lead 1 6 Battery positive lead 1 7 Battery 1 8 Battery seat 1

Removing the headlight and meter assembly (FZ1-N(X)), (FZ1-NA)
Order Job/Parts to remove Quantity Remarks 1 Headlight side cover bolt (left and right) 4 2 Headlight coupler 1 Disconnect. 3 Headlight sub-wire harness coupler 1 Disconnect. 4 Headlight assembly 1 5 Headlight bracket 2 6 Headlight side cover (left...

Removing the front cowling (FZ1-S(X)/FZ1-SA)
Order Job/Parts to remove Quantity Remarks 1 Inner panel 2 2 Headlight assembly coupler 1 Disconnect. 3 Meter coupler 1 Disconnect. 4 Front cowling assembly 1 5 Rear view mirror 2 6 Cowling stay 1 7 Meter assembly 1 8 Headlight unit 1

Removing the under cowling (FZ1-NA)
Order Job/Parts to remove Quantity Remarks 1 Under cowling 1 2 Rectifier/regulator 1 3 Right under cowling bracket 1 4 Left under cowling bracket 1

Removing the rear fender (FZ1-N(X)), (FZ1-NA)
Order Job/Parts to remove Quantity Remarks Rider and passenger seat Refer to « General chassis ». 1 Licence plate light lead coupler 1 Disconnect. 2 Turn signal light lead coupler 1 Disconnect. 3 Mud guard assembly 1 4 Rear fender 1 5 Tail/brake...

Removing the rear fender (FZ1-S(X)/FZ1-SA)
Order Job/Parts to remove Quantity Remarks Rider and passenger seat Refer to « General chassis ». 1 Licence plate light lead coupler 1 Disconnect. 2 Turn signal light lead coupler 1 Disconnect. 3 Mud guard assembly 1 4 Rear fender 1 5 Tail/brake...

Removing the air filter case
Order Job/Parts to remove Quantity Remarks Rider and passenger seat Refer to « General chassis ». Fuel tank Refer to « Fuel tank ». 1 Intake air temperature sensor lead coupler 1 Disconnect. 2 Intake air temperature sensor 1 3 Air filter case cover...

Removing the cover
1. Remove: Tail cover Rear fender Note: To remove the quick fastener, push its center with a screwdriver, then pull the fastener out.

Installing the cover
1. Install: Rear fender Tail cover Note: To install the quick fastener, push its pin so that it protrudes from the fastener head, then insert the fastener into the cover and push the pin «a» in with screwdriver. Make sure that the pin is flush with...