Caution! Do not allow brake fluid to come into contact with painted parts of the motorcycle as brake fluid destroys paint.
Drain the brake system.
Disconnect brake line (1) from brake caliper.
Remove screws securing the brake caliper.
Installation is the reverse of the removal procedure.
Force back the brake pads and pistons.
Fill and bleed the brake system.
Caution!
- Replace the sealing rings (2) in the brake line. Do not damage brake pads.
- [ABS] Check sensor gap and adjust if necessary with shim.
Sensor gap: 0.45...0.55 mm (0.018...0.022 in)
Tightening torque:
- Brake caliper to rear wheel drive — 40 Nm
- Brake line to brake caliper — 18 Nm
- Bleed screw in brake caliper — 6 Nm