Removing and installing rear ABS sensor (BMW R1150GS)

0

Before removing/installing, clean the sensor bore.

Using Torx T25, slacken sensor (1).

Disconnect plug (2) of sensor cable.

Installation is the reverse of the removal procedure.

Coat O-rings with oil before installing.

Caution!

• Route the sensor cable correctly.
• Check sensor gap and adjust if necessary with shims (3).

Sensor gap: 0.45...0.55 mm (0.018...0.022 in)

Tightening torque: Sensor — handtight, 4 Nm

See this article in russian language

Article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004): «Removing and installing rear ABS sensor»: https://motoinstruction.ru/en/BMW/R/R1150GS/chassis/brake/111741 <a href="https://motoinstruction.ru/en/BMW/R/R1150GS/chassis/brake/111741">Removing and installing rear ABS sensor</a> - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Brake system». [url=https://motoinstruction.ru/en/BMW/R/R1150GS/chassis/brake/111741]Removing and installing rear ABS sensor[/url] - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Brake system».