Removing and installing rear brake disc (mounted on rear-wheel hub) (BMW R1150GS)

0

Remove screws securing the brake caliper.

Remove rear wheel.



Remove brake disc.

Installation is the reverse of the removal procedure.

Degrease the brake disc before installing.

Caution! [ABS] Check sensor gap and adjust with shims if necessary.

Sensor gap: 0.45...0.55 mm (0.018...0.022 in)

Tightening torque:

• Brake disc to rear wheel drive (clean thread + Loctite 243) — 21 Nm

See this article in russian language

Article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004): «Removing and installing rear brake disc (mounted on rear-wheel hub)»: https://motoinstruction.ru/en/BMW/R/R1150GS/chassis/brake/111738 <a href="https://motoinstruction.ru/en/BMW/R/R1150GS/chassis/brake/111738">Removing and installing rear brake disc (mounted on rear-wheel hub)</a> - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Brake system». [url=https://motoinstruction.ru/en/BMW/R/R1150GS/chassis/brake/111738]Removing and installing rear brake disc (mounted on rear-wheel hub)[/url] - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Brake system».