1. IAT sensor lead wire; 2. HO2 sensor lead wire; 3. Wiring harness; 4. Throttle cable; 5. Clutch cable; 6. Handlebar switch left; 7. Water hose; 8. High-tension cord; 9. Side-stand switch
*1 Insert the protruded section each on the handlebar switch lead wire coupler, ignition switch lead wire coupler and cooling fan motor lead wire coupler into the respective holes provided on the frame.
*2 Route the wiring harness under the cowling fastener fitted section.
1. Wiring harness No.2; 2. Magneto lead wire; 3. Ignition coil No.2
*1 Clamp the turn signal light read wire.
*2 Pass through the license light read wire over the seat lock cable.
*3 Triangle mark of each spark plug cap must be brought to the exhaust side.
*4 Cut the clamp end.
*5 Do not slack the lead wire.
*6 Pass through the PAIR reed valve lead wire between the frame and PAIR control solenoid valve.