Component parts and work to be done Under the name of each system or unit, is its exploded view. Work instructions and other service information such as the tightening torque, lubricating points and locking agent points, are provided. Example: Front wheel 1. Brake disc; 2. Dust seal;...
Abbreviations used in this manual A ABDC: After Bottom Dead Center AC: Alternating Current ACL: Air Cleaner. Air Cleaner Box API: American Petroleum Institute ATDC: After Top Dead Center ATM Pressure: Atmospheric Pressure Atmospheric Pressure Sensor (APS) A/F: Air Fuel Mixture В...
Sae-to-former suzuki term This table lists SAE (Society of Automotive Engineers) J1930 terms and abbreviations which may be used in this manual in compliance with SAE recommendations, as well as their former SUZUKI names. SAE TERM FORMER SUZUKI TERM FULL TERM ABBREVIATION A...
Warning/caution/note of general information Please read this manual and follow its instructions carefully. To emphasize special information, the symbol and the words WARNING, CAUTION and NOTE have special meanings. Pay special attention to the messages highlighted by these signal words....
General precautions Warning: Proper service and repair procedures are important for the safety of the service mechanic and the safety and reliability of the motorcycle. When 2 or more persons work together, pay attention to the safety of each other. When it is...
Motorcycle appearance Suzuki DL1000K2 ('02-model) Right side Left side *Difference between photographs and actual motorcycles may exist depending on the markets.
Serial number location The frame serial number or V.I.N. (Vehicle Identification Number) (1) is stamped on the right side of the steering head pipe. The engine serial number (2) is located on the right side of the crankcase. These numbers are required especially for...
Fuel, oil and engine coolant recommendation* Fuel (for usa model) Use only unleaded gasoline of at least 87 pump octane (R+M) or 91 octane or higher rated by the research method. Gasoline containing MTBE (Methyl Tertiary Butyl Ether), less than 10% ethanol, or less than 5% methanol with...
Break-in procedures During manufacture only the best possible materials are used and all machined parts are finished to a very high standard but it is still necessary to allow the moving parts to "BREAK-IN" before subjecting the engine to maximum stresses. The future...
Cylinder identification The two cylinders of this engine are identified as No. 1 and No. 2 cylinder, as counted from front to rear (as viewed by the rider on the seat).
Specifications of General information Dimensions and dry mass Overall length — 2295 mm (90.4 in) Overall width — 865 mm (34.1 in) Overall height — 1335 mm (52.6 in) Wheelbase — 1535 mm (60.4 in) Ground clearance — 165 mm (6.5 in) Seat height — 840 mm (33.1 in) Dry mass — 207 kg (456...
Country and area codes The following codes stand for the applicable country(-ies) and area(-s). CODE COUNTRY or AREA E-02 U. K. E-03 U. S. A. (Except for California) E-19 EU E-24 Australia E-28 Canada E-33 California (U. S. A.)