Cautions in servicing Connector When connecting a connector, be sure to push it in until a click is felt. Inspect the connector for corrosion, contamination and breakage in its cover. Coupler With a lock type coupler, be sure to release the lock before disconnecting it...
Side-stand/ignition interlock system parts — inspection Check the interlock system for proper operation. If the interlock system does not operate properly, check each component for damage or abnormalities. If any abnormality is found, replace the component with a new one. Side-stand switch Remove the...
Combination meter — removal and disassembly Disconnect the battery (-) lead wire. Remove the combination meter panel. ( 7-6 ). Remove the combination meter (1). Caution! When disconnecting and connecting the combination meter coupler, make sure to turn OFF the ignition switch, or electronic...
Combination meter — inspection LED (light emitting diode) Check that the LED lights immediately after turning the ignition switch on. If the LED fails in operation, replace the combination meter unit with a new one after checking its wire har-ness/coupler. Stepping motor Check...
Engine coolant temperature meter inspection Disconnect the ECT sensor coupler (1). Caution! When connecting and disconnecting the ECT sensor lead wire coupler, make sure to turn OFF the ignition switch, or electronic parts may get damaged. Connect the variable resistor (A) between the...
Fuel level gauge inspection Remove the fuel tank. ( 5-7 ) Remove the fuel pump. ( 5-10 ) Measure the resistance at each fuel level gauge float position. If the resistance is incorrect, replace the fuel level gauge with a new one. Float position Resistance (A) "F" (Full)...
Fuel level meter inspection Remove the fuel tank left side cover. ( 7-4 ) Disconnect the fuel pump lead wire coupler. Connect the each resistor between the Yellow/Black and Black/White lead wires at the wire harness. Turn the ignition switch "ON" position and wait for approx....
Oil pressure indicator inspection Note: Before inspecting the oil pressure switch, check the engine oil level. ( 2-13 ) Disconnect the oil pressure switch lead wire from the oil pressure switch. Turn the ignition switch "ON" position. Check if the oil pressure indicator will light,...
Speedometer and speed sensor If the speedometer, odometer or trip meter does not function properly, inspect the speed sensor and connection of coupler (1). If the speed sensor and connection are all right, replace the meter with a new one. Speed sensor removal and installation...
Headlight, brake light/taillight and turn signal light Headlight 12 V 60/55 W 12 V 60/55 W + 5 W (A) ONLY E-02, 19 Brake light/tail light 12 V 21/5 W Turn signal light 12 V21 W Headlight beam adjustment Adjust the headlight beam, both vertical and horizontal. (A): Vertical adjuster; (B): Horizontal...
Turn signal/side-stand relay — inspection The turn signal/side-stand relay is composed of the turn signal relay, side-stand relay and diode. Inspection Before removing the turn signal/side-stand relay, check the operation of the turn signal light. If the turn signal light does not...
Ignition switch — removal Remove the fuel tank. ( 5-7 ) Remove the air cleaner box. ( 5-15 ) Disconnect the ignition switch coupler (1). Remove the ignition switch mounting bolts with the special tools. 09930-11920: Torx bit JT40H 09930-11940: Bit holder Caution! When...
Ignition switch — inspection Inspect each switch for continuity with a tester. If any abnormality is found, replace the respective switch assemblies with new ones. Ignition switch Dimmer switch Turn signal light switch Passing light switch Engine stop switch Starter button Horn...