| Order | Job name/Part name | Quantity | Remarks |
| Removing the rear brake master cylinder | Remove the parts in the order listed. | ||
| Brake fluid | Drain | ||
| 1 | Brake switch connector | 1 | Disconnect |
| 2 | Cotter pin/washer | 1/1 | |
| 3 | Pin | 1 | |
| 4 | Bolts | 2 | |
| 5 | Brake pedal assembly | 1 | |
| 6 | Union bolt | 1 | Refer to "Removing/installing the rear brake master cylinder". |
| 7 | Copper washers/brake hose | 2/1 | |
| 8 | Clips/reservoir hose | 2/1 | |
| 9 | Master cylinder assembly | 1 | |
| 10 | Reservoir tank | 1 |
For installation, reverse removal procedure.
Note: Before removing the rear brake master cylinder, drain the brake fluid from the entire brake system.
1. Remove:
- brake switch connector
- cotter pin/washer
- pin
- bolt/brake pedal assembly
2. Remove:
- union bolt (1)
- copper washers (2)
- brake hose (3)
Note: To collect any remaining brake fluid, place a container under the master cylinder and the end of the brake hose.
3. Remove:
- clips/reservoir hose
- master cylinder assembly