![](https://motoinstruction.ru/img/yamaha/3/112032.jpg)
Order | Job/Parts to remove | Quantity | Remarks |
Rider and passenger seat | Refer to «General chassis». | ||
1 | Fuel hose | 1 | Disconnect. |
2 | Fuel sender coupler | 1 | Disconnect. |
3 | Fuel pump coupler | 1 | Disconnect. |
4 | Fuel tank drain hose | 1 | Disconnect. |
5 | Fuel tank breather hose | 1 | Disconnect. |
6 | Fuel tank | 1 | |
7 | Fuel tank cover | 1 | |
8 | Fuel pump | 1 |
1. Extract the fuel in the fuel tank through the fuel tank cap with a pump.
2. Remove:
- Fuel hose connector cover
- Fuel hose
- Fuel sender coupler
- Fuel pump coupler
- Fuel tank breather hose
- Fuel tank drain hose
Cautions!
- Be sure to disconnect the fuel hose by hand. Do not forcefully disconnect the hose with tools.
- Although the fuel has been removed from the fuel tank be careful when removing the fuel hoses, since there may be fuel remaining in it.
Notes:
- To remove the fuel hose from the fuel injection pipe, slide the cover «a» on the end of the hose in the direction of the arrow shown and then remove the hose.
- Before removing the hoses, place a few rags in the area under where it will be removed.
![](https://motoinstruction.ru/img/yamaha/3/112033.jpg)
3. Remove:
- Fuel tank
Note: Do not set the fuel tank down so that the installation surface of the fuel pump is directly under the tank. Be sure to lean the fuel tank in an upright position.