- Brush holder
- Armature assembly
Nut 5 Nm (0.5 m·kgf, 3.6 ft·lbf). O-ring New.
a. Pull both the brush spring "1" and the brush "2" outside and hook the brush spring to the groove portion at the side of the brush.
b. Insert the armature assembly "3" into the brush holder "4" and push the brush "5" inside until it touches the armature assembly.
2. Install:
- Rear cover "1"
Align the tab "a" on the brush holder "2" with the tab "b" in the rear cover.
3. Install:
- Washer
- Nut"1"
Nut 5 Nm (0.5 m·kgf, 3.6 ft·lbf).
4. Install:
- Starter motor yoke "1"
- Gaskets "2"
- Front cover"3"
- Starter motor assembling bolts "4"
Starter motor assembling bolt 5 Nm (0.5 m·kgf, 3.6 ft·lbf).
Align the match marks "a" on the starter motor yoke with the match marks "b" on the front and rear covers.
