Brake disc (7-65).
Remove the brake discs.
Dust seal
Inspect the dust seal lip for wear or damage. If any damages are found, replace the dust seal with a new one.
Remove the dust seal with the special tool.
- 09913-50121: Oil seal remover
Caution! Do not reuse the removed dust seals.
Front axle
Using a dial gauge, check the front axle for runout and replace it if the runout exceeds the limit.
- 09900-20607: Dial gauge (1/100)
- 09900-20701: Magnetic stand
- 09900-21304: V-block set (100 mm)
Axle shaft runout:
- Service Limit: 0.25 mm (0.010 in)
Wheel
Make sure that the wheel runout checked as shown does not exceed the service limit. An excessive runout is usually due to worn or loosened wheel bearings and can be reduced by replacing the bearings. If bearing replacement fails to reduce the runout, replace the wheel. (Wheel inspection: 7-79)
Wheel runout:
- Service Limit (Axial and Radial): 2.0 mm (0.08 in)
Wheel bearing
Inspect the play of the wheel bearings by finger while they are in the wheel. Rotate the inner race by finger to inspect for abnormal noise and smooth rotation.
Replace the bearing in the following procedure if there is anything unusual.
Remove the wheel bearings with the special tool.
- 09921-20240: Bearing remover set (∅17)
Caution! Do not reuse the removed bearings.
