CKP sensor
Inspection
The crankshaft position sensor is installed in the generator cover. (4-23)
Removal and installation
Remove the generator cover. (3-26)
Install the generator cover in the reverse order of removal.
IAP sensor
Inspection
The intake air pressure sensor is installed at the rear side of the air cleaner box. (4-25)
Removal and installation
Lift and support the fuel tank. (5-7)
Remove the IAP sensor from the air cleaner box.
Install the IAP sensor in the reverse order of removal.
TP sensor
Inspection
The throttle position sensor is installed at the left side of the No.2 throttle body. (4-28)
Removal and installation
Remove the air cleaner box. (5-15)
Remove the TP sensor. (5-19)
Install the TP sensor in the reverse order of removal.
- TP sensor mounting screw: 3.5 N·m (0.35 kgf·m, 2.5 ib-ft)
TPS adjustment
Adjust the TP sensor. (5-29)
ECT sensor
Inspection
The ECT sensor is installed on the thermostat case. (4-31)
Removal and installation
Remove the ECT sensor. (6-10)
Install the ECT sensor in the reverse order of removal.
- ECT sensor: 19 N·m (1.9 kgf·m, 13.5 lb·ft)
IAT sensor
Inspection
The intake air temperature sensor is installed on the right side of the air cleaner box. (4-33)
Removal and installation
Lift and support the fuel tank. (5-7)
Remove the IAT sensor from the air cleaner box.
Install the IAT sensor in the reverse order of removal.
- IAT sensor: 18 N·m (1.8 kgf·m, 13.0 lb·ft)
TO sensor
Removal and installation
The tip over sensor is located in under the seat. (4-35)
Remove the right frame cover. (7-5)
Remove the TO sensor from the rear fender.
Install the TO sensor in the reverse order of removal.
Note: When installing the TO sensor, the "UP" mark (A) must be pointed upward.
STP sensor
Removal and installation
The secondary throttle position sensor is installed at the left side of the No.2 throttle body.
Remove the air cleaner box. (5-15)
Remove the STP sensor. (5-19)
Install the STP sensor in the reverse order of removal.
- STP sensor mounting screw: 2.0 N·m (0.2 kgf·m, 1.5 lb·ft)
Adjustment
Adjust the STP sensor. (5-28)
HO2 sensor
Removal and installation
The HO2 sensor is installed at the exhaust pipe.
Remove the seat. (7-4)
Disconnect the HO2 sensor lead wire coupler and remove the HO2 sensor.
Install the HO2 sensor in the reverse order of removal.
- HO2 sensor: 47.5 N·m (4.75 kgf·m, 34.3 lb·ft)
