Troubleshooting
Check the condition of the 15A fuse.
Check wiring connection.
Rev counter
Fit a substitute rev counter known to operate properly.
Coolant temperature
Disconnect the green-grey terminal wire and connect three resistors rated 1,000 Ω, 50 Ω and 15 Ω, respectively as shown.
When the ignition key is turned to ON, the following temperature readings or messages will appear on the display.
| Resistor rating | Display indication |
| 1,000 Ω | COLD |
| 50 Ω | 90-95°C |
| 15 Ω | 120-130°C |
If display indications are correct, change the thermistor. Otherwise change the display.
1) Resistor; 2) Thermistor
Oil level sensor test
Disconnect all leads at the wiring harness end and remove the sensor from the frame.
Attach a multimeter set to the ohm range to the sensor.
Hold sensor vertically. Correct reading: 0 Ω.
Turn sensor over. Correct reading: infinite resistance.