Use the special tool in the following procedures, to cut and rejoin the drive chain.
- 09922-22711: Drive chain cutting and joining tool set
Note: When using the special tool, apply a small quantity of grease to the threaded parts of the special tool.
Set up the special tool as shown in the illustration.
1. Tool body; 2. Grip handle; 3. Pressure bolt "A"; 4. Pressure bolt "B"; 5. Bar; 6. Adjuster bolt (with through hole); 7. Pin remover; 8. Chain holder (engraved mark 500) with reamer bolt M5x10
Note: The tip of pin remover (7) should be positioned inside (A) approximately 5 mm (0.2 in) from the end face of pressure bolt "A" (3) as shown in the illustration.
Place the drive chain link being disjointed on the holder part (8) of the tool.
Turn in both the adjuster bolt (6) and pressure bolt "A" (3) so that each of their end hole fits over the chain joint pin properly.
Tighten the pressure bolt "A" (3) with the bar.
Turn in the pressure bolt "B" (4) with the bar (5) and force out the drive chain joint pin (9).
Caution! Continue turning in the pressure bolt "B" (4) until the joint pin has been completely pushed out of the chain.
Note: After the joint pin (9) is removed, loosen the pressure bolt "B" (4) and then pressure bolt "A" (3).
Remove the joint pin (9) of the other side of joint plate.
Caution! Never reuse joint pins, O-rings and plates. After joint pins, O-rings and plates have been removed from the drive chain, the removed joint pins, O-rings and plates should be discarded and new joint plate, O-rings and plate must be installed.