Installing the motorcycle on a stand (Aprilia Shiver 750)
If the support has been removed for maneuvering (for example, while the vehicle is moving), to install the vehicle on the support, perform the following steps:
(The article is reprinted from this website motoinstruction.ru)
- Choose a suitable parking spot.
- Grab the left handle (1) and place your right hand on the top rear of the vehicle (2).
- Press the side support with your right foot and open it completely (3).
- Tilt the vehicle until the support is on the ground.
- Turn the steering wheel all the way to the left.

Attention! Make sure the parking area is clean and has a hard, level surface.
Attention! Make sure the vehicle is stable.
(The article is reprinted from this website motoinstruction.ru)
See this article in russian language
This article has been reviewed: Serafim Sazonov
Similar articles about motorcycles of other brands
Removing the centre stand and kick stand Ducati ST2 (1997-2003)Removing and installing main (centre) stand BMW R 1150 GS (1999-2004)
Installing the side stand spring Suzuki DRZ 250 (1996-2007)
Pull-out stand Harley-Davidson V-Rod (2002-2006)
Center stand — removal and installation Honda CB 400 SF (1992-1999)
Comments and feedback from visitors
No comments yet, you will be the first!
