Removing the throttle body (Ducati ST2)

0

Loosen the clips (1) and (2) on the intake manifolds.



Disconnect the throttle body from the intake manifolds but leave it connected to the accelerator and choke cables and to the main cable.

At reassembly, the clips (1) and (2) must be fixed with the clamping screws pointing downwards faced towards the right-hand side as shown in the figures.

Note. When fitting new accelerator and choke cables, position the cables as shown in the figure.

Caution! Do not fix accelerator and choke cables with clips or cable ties.

See this article in russian language

Article about repair motorcycles «Ducati ST series ST2» (1997-2003): «Removing the throttle body»: https://motoinstruction.ru/en/Ducati/ST/ST2/engine/fuel/112082 <a href="https://motoinstruction.ru/en/Ducati/ST/ST2/engine/fuel/112082">Removing the throttle body</a> - article about repair motorcycles «Ducati ST series ST2» (1997-2003) from section «Fuel and exhaust system». [url=https://motoinstruction.ru/en/Ducati/ST/ST2/engine/fuel/112082]Removing the throttle body[/url] - article about repair motorcycles «Ducati ST series ST2» (1997-2003) from section «Fuel and exhaust system».