Remove the following:
Remove the throttle stop screw from the guide.
Always replace the sealing washers when the fuel hose banjo bolt is removed or loosened.
Disconnect the TP sensor 3P gray connector and MAP sensor 3P black connector.
Loosen the band screw and disconnect the water hose.
Remove the sub-harness from the clamp.
Remove the bolts, clamp and throttle body.
Remove the O-ring.
Loosen the lock nuts and disconnect the throttle cables from the throttle drum.
Do not snap the throttle valve from fully open to fully closed after the throttle cable has been removed. It may cause incorrect idle operation.
Loosen the band screw and disconnect the water hose.
Do not snap the throttle valve from fully open to fully closed after the throttle cable has been removed. It may cause incorrect idle operation.
Notice:
- Do not damage the throttle body. It may cause incorrect throttle and idle valve synchronization.
- The throttle body is factory pre-set. Do not disassemble in a way other than shown in this manual.
- Do not loosen or tighten the white painted bolts and screws of the throttle body. Loosening or tightening them can cause throttle and idle valve synchronization failure.
