Sidecar configuration
Warning! Only Touring Harley-Davidson Motorcycles are suitable for sidecar use. Consult a Harley-Davidson dealer. Use of motorcycles other than Touring models with sidecars could result in death or serious injury.
All motorcycles ship with the H-DSSS set for use without a sidecar installed. If a motorcycle is equipped with a TSM, no further actuation is required.
Actuation
Actuation consists of assigning two fobs to the system, and entering an initial PIN. The PIN can be changed by the rider at any time.
1. Configure vehicles by assigning both fobs to the vehicle.
2. Configure vehicles by entering a PIN picked by the owner. The personal code allows the owner to operate the system if the fob is lost or inoperable. Record the PIN in the owner's manual. Instruct the customer to carry a copy (use the wallet card found in the owner's manual). See 6.36 PERSONAL IDENTIFICATION NUMBER (PIN).
Once the system has been activated, it will always "arm" within 5 seconds of turning the ignition switch to OFF or ACC and no motorcycle motion.
Fob assignment
| PART NUMBER | TOOL NAME |
| HD-48650 | DIGITAL TECHNICIAN II |
Use DIGITAL TECHNICIAN II (Part No. HD-48650) to assign both fobs to the H-DSSS. Follow the menu prompts to scan the fob serial number with the bar code reader. Alternatively, enter the number using the keyboard. The initial PIN entry should be performed using DIGITAL TECHNICIAN II (Part No. HD-48650) in conjunction with fob assignment.
Note. Each fob has a unique serial number. Attach fob label to a blank NOTES page in the owner's manual for reference.
Power disruption and configuring
The following actions may result in a removal of battery voltage from the TSM/HFSM:
- Battery disconnect
- Power drain
- Battery fuse removal
- Connecting a breakout box to the TSM/HFSM connector
After battery voltage has been removed from terminal 1 of the TSM/HFSM, the module will not enter the PIN entry mode on the first attempt. Initialize the PIN entry configuration sequence twice before entering the PIN:
- 1. Set engine OFF/RUN switch to OFF.
- 2. Cycle the ignition switch:
- a. IGNITION
- b. OFF
- c. IGNITION
- d. OFF
- e. IGNITION
- 3. Press the left turn signal switch twice.
- 4. Repeat the previous steps.
- 5. Continue with the PIN entry sequence.