See Figure A-13. An AFL housing (5) is used on many igni-tion/light switches. The secondary lock (4) must be opened before removing the terminal from the housing.
Separating pin and socket housings
Notes:
Record position of cable straps anchoring wire conduits of the pin and socket housing before removing them.
Cut any cable strap anchoring the wire conduits of the pin (accessory connector housing) and the socket (B+) housing.
See Figure A-13. Using small flat blade screwdriver, press button (1) on pin housing (red wire) side of the connector and pull apart the pin and socket housings.
Mating pin and socket housings
Orient the latch on the socket housing to the button catch on the pin housing and press the housings together.
Removing socket terminals
1. See Figure A-13. Bend back the latch (2) slightly and free one side of secondary lock, then repeat to release the opposite side. Rotate the secondary lock outward on hinge to access terminal in chamber of connector housing.
![](https://motoinstruction.ru/img/harley/12/118404.jpg)
Figure A-13. Delphi 480 metri-pack unsealed connector: remove socket terminal: 1. Button on pin housing; 2. Secondary lock latch; 3. Opening between tang and chamber wall; 4. Secondary lock (shown open); 5. AFL housing
2. On the mating end of the connector, note the tang in the square shaped opening centered next to the terminal. Gently insert the point ofa stick pin or large safety pin into the opening (3) between the tang and the chamber wall until it stops.
3. Pivot the end of the pin toward the terminal body to press the tang.
4. Remove the pin and then pull terminal out of the wire end of connector housing.
5. If necessary, crimp new terminals on wires. See A.9 DELPHI METRI-PACK TERMINAL REPAIR.
Installing socket terminals
1. Carefully bend the tang outward away from the terminal body.
2. With the tang on the same side as the square shaped opening in the mating end of the connector housing, feed terminal into wire end of connector housing until it clicks in place.
3. Verify that terminal will not back out of the chamber. A slight tug on the cable will confirm that it is locked.
4. Rotate the hinged secondary lock inward until latches fully engage tabs on both sides of connector housing.
Note. If removed, install new anchored cable strap in original equipment location. Tighten cable strap to capture conduit of both accessory connector and B+ connector approximately 1.0 in (25.4 mm) from housings.