Table 6-13. Password learn
DEVICE REPLACED | IS PASSWORD LEARN NECESSARY? |
ECM | Yes |
TSM | No* |
TSM/HFSM | Yes |
* If a TSM has been replaced by a HFSM, or a HFSM has been replaced by a TSM, password learn is necessary.
Password learn
PART NUMBER | TOOL NAME |
HD-48650 | DIGITAL TECHNICIAN II |
To perform the password learn procedure, referto Table 6-14. When finished, continue with all instructions under 6.37 H-DSSS ACTUATION.
TSM/HFSM: Always perform all appropriate instructions under 6.37 H-DSSS ACTUATION after TSM/HFSM replacement or removal.
TSM/TSSM (Japan/Korea markets): Always perform all appropriate instructions under VEHICLE DELIVERY in the electrical diagnostic manual after TSM/TSSM replacement or removal.
Notes:
- HFSM: Fob assignment must be performed at an authorized Harley-Davidson dealer using DIGITAL TECHNICIAN II (Part No. HD-48650).
- TSSM: Do not forget to enter a Personal Identification Number (PIN) for TSSM vehicles. Ifa code is not assigned and the key fob is lost or damaged while the vehicle is armed, the TSSM must be replaced.
Table 6-14. Setting TSM/TSSM/HFSM and ECM password
NO. | ACTION | CONFIRMATION | NOTES |
Ignition must be turned off for at least 15 seconds. | With Ignition Switch turned off, Check Engine lamp and Security lamp will be off. | ||
1 | Install new TSM/TSSM/HFSM or ECM. | ||
2 | Set Engine Stop Switch to RUN. | ||
3 | Turn Ignition Switch ON. | Verify Check Engine lamp and Security lamp illuminate and then turn off. | TSM/HFSM enables start relay. |
4 | Attempt normal start one time. | Engine starts and stalls. Check Engine lamp illuminates and stays on. | Password has not been learned. ECM sets DTC P1009. |
5 | Waitten seconds. Security lamp will illuminate and stay on. | Security lamp illuminates. | ECM enters Password Learning mode for ten minutes. Do not cycle Ignition Switch or interrupt vehicle power or Password Learn will be unsuccessful. |
6 | Wait until Security lamp turns off. | This takes ten minutes. | |
7 | Quickly (within two seconds) turn Ignition Switch OFF-ON. | ECM must not be allowed to shutdown. | |
8 | Wait until Security lamp turns off. | This takes ten minutes. | |
9 | Quickly (within two seconds) turn Ignition Switch OFF-ON. | ECM must not be allowed to shutdown. | |
10 | Wait until Security lamp turns off. | This takes ten minutes. | |
11 | Quickly (within two seconds) turn Ignition Switch OFF-ON. | ECM must not be allowed to shutdown. | |
12 | Turn Ignition Switch OFF. Wait 15 seconds before turning Ignition Switch on. Turn Ignition Switch ON and start engine to confirm successful Password Learn procedure. Clear DTCs. | ||
13 | TSM/HFSM: Perform all steps under 6.37 H-DSSS ACTUATION. TSM/TSSM (Japan/Korea markets): Perform all steps under VEHICLE DELIVERY in electrical diagnostic manual. |