1. Use a thin slotted screwdriver or an awl to pry up and remove the decorative plugs for the steering column bolts.
2. With a 6 mm hex wrench, unscrew the four bolts of the steering racks.
3. Remove the top covers of the steering racks.
4. Remove the steering wheel from the seat.
Attention! The top surfaces of the rack covers are labeled (points). They serve to ensure that the covers are properly oriented during installation. Covers must be installed point up (marks should be located at the front bolts).
The installation is carried out in the reverse order, while the steering wheel during installation must be positioned so that the notches of the steering pipe are in the grooves of the racks, and the special mark on the pipe is located exactly on the cut of the steering rack horizontally (a dot stamped on the rudder tube next to the notch).