Instrumentation and controls Honda CB400SF/1 (1992-1999)

Steering wheel and attachments — disassembly and assembly
Disassembly Using a 17 mm wrench, unscrew both rear view mirrors to avoid damaging them when further removing the steering switch blocks. Removing the clutch cable (see « Clutch cable - removal and installation, adjustment »). 1. Using a 10 mm...

Instrument panel — disassembly and assembly
Before disassembling the instrument panel, it must be removed from the motorcycle (see « Instrument panel - replacement of backlight and control lamps »). Disassembly 1. Using a Phillips screwdriver, unscrew the three screws of the instrument panel...

Control cables — inspection and lubrication
Maintenance of control cables consists of regularly lubricating them and checking for damage. The cables are lubricated with engine oil every 10,000 km using a homemade oiler, as shown in the figure. 1 - oil; 2 - capacity; 3 - lubricated cable Also,...

Speedometer drive cable — removal and installation
Removing 1. Using a Phillips screwdriver, unscrew the nut securing the cable to the dashboard. 2. Remove the cable from the dashboard by sliding it down. 3. Using a Phillips screwdriver, unscrew the cable from the gearbox on the front wheel axle. 4....

Clutch cable — removal and installation, adjustment
To remove the clutch cable, you must remove the fuel tank (see « Fuel tank - removal and installation »). Removing 1. Using a 12 mm wrench, unscrew nuts 1 and 2 of the clutch cable to ensure free play of the cable sheath. 2. We unscrew the adjusting...

Throttle actuator cables — removal and installation
To remove the throttle cable, you must first remove the fuel tank (see « Fuel tank - removal and installation »), also for ease of installation of cables, it may be necessary to remove the bar of carburetors (see « Plank carburetors - removal and...

Starting enricher drive cable — removal and installation
To remove the starting enricher drive cable, you must first remove the fuel tank (see « Fuel tank - removal and installation »). Removing 1. Using a Phillips screwdriver, loosen the screw that secures the starting enrichment cable. 2. We remove the...

Gear shift pedal — removal, installation and adjustment
Removing 1. With a 6 mm hex wrench, unscrew the axis of the gear shift pedal. 2. Using a 10 mm wrench, unscrew the locking bolt of the gear shift pedal bracket. 3. Remove the gear shift pedal clip by sliding it towards you. Installation Installation...

Rear brake pedal — removal and installation
To remove the rear brake pedal, you must first remove the pedal mounting bracket (see « Footrest brackets - removal and installation »). Removing 1. Using pliers, remove the rear brake sensor spring. 2. Use pliers to remove the rear brake pedal...