| Order | Job/Parts to remove | Quantity | Remarks |
| Rider and passenger seat | Refer to «General chassis». | ||
| Fuel tank | Refer to «Fuel tank». | ||
| Engine oil | Drain. Refer to «Changing the engine oil». | ||
| 1 | Stator coil assembly lead coupler | 1 | Disconnect. |
| 2 | Plug | 1 | |
| 3 | Generator rotor cover | 1 | |
| 4 | Gasket | 1 | |
| 5 | Dowel pin | 2 | |
| 6 | Generator rotor assembly | 1 | |
| 7 | Stator coil assembly | 1 | |
| 8 | Dowel pin | 2 | |
| 9 | Bearing housing | 1 | |
| 10 | Collar | 1 | |
| 11 | Bearing | 1 | |
| 12 | Stator coil assembly lead holder | 1 | |
| 13 | Idler gear | 1 | |
| 14 | Idler gear shaft | 1 | |
| 15 | Washer | 1 | |
| 16 | Bearing | 1 |
1. Remove:
- Plug
- Generator rotor cover «1»
Notes:
- While pushing generator rotor, remove the generator rotor cover.
- Loosen each bolt 1/4 of a turn a time, in stages and in a crisscross pattern.
- After all of the bolts are fully loosened, remove them.
2. Remove:
- Generator rotor and starter clutch assembly «1»
3. Remove:
- Idle gear shaft bolt «1»
- Idle shaft
- Idle gear «2»
