- Bearings
- Spacer
- Dustcover
- Pivot shaft
Recommended lubricant. Lithium-soap-based grease.
2. Install:
- Bearings "1"
- Bearing "2"
- Circlip "3"
- Oil seal "4"
Installed depth of bearing "a" 0-1.0 mm (0-0.04 in).
5. Dust cover; 6. Collar; 7. Swingarm; 8. Pivot shaft; A. Left side; B. Right side
3. Install:
- Pivot shaft "1"
Pivot shaft 7 Nm (0.7 m·kgf, 5.1 ft·lbf).
Tighten the pivot shaft with the damper rod holder (22 mm) "2".
Damper rod holder (22 mm) 90890-01365.
4. Install:
- Pivot shaft ring nut "1"
Pivot shaft ring nut 65 Nm (6.5 mr·kgf, 47 ft·lbf).
Tighten the pivot shaft ring nut with the ring nut wrench "2".
Ring nut wrench 90890-01507 YM-01507.
5. Install:
- Pivot shaft nut "1"
Pivot shaft nut 105 Nm (10.5 mr·kgf, 75 ft·lbf).
Lubricant the pivot shaft with lithium-soap based grease.
6. Adjust:
- Drive chain slack
Refer to "Adjusting the drive chain slack".
Drive chain slack (when adjusting the drive chain) 25.0-35.0 mm (0.98-1.38 in).
Drive chain slack (when replacing the drive chain and sprocket) 20.0-30.0 mm (0.79-1.18 in).