Remove the battery.
Remove the intake air silencer together with the intake air pipe.
Remove the fastener for the intake air silencer from the oil tank.
Remove the fasteners for the intake air silencer from the retainer.
Remove the starter relay from the holder.
Slacken the fasteners for the lid of the electronic equipment box.
Remove the fasteners for the battery tray.
Disengage the clamp securing the breather hose and disconnect the hose from the intake air silencer.
Press the oil tank slightly to the left and carefully disconnect the intake air silencer from the throttle flap stub.
Pull the intake air silencer with intake air pipe and battery carrier to the rear to remove.
Cover/seal the throttle flap stub.
Disengage cover (1) from the anchorages on main frame on each side and remove.
Disconnect starter coil (2) at plug.
Pull spark plug connector (4) off spark plug.
Remove screws securing ignition coil (3) to cylinder head cover.
Tightening torques:
- Ignition coil to cylinder head: 9 Nm
- Lid of electronic equipment box: 4 Nm
- Oil tank to intake air silencer: 9 Nm
- Intake air silencer to frame: 9 Nm
- Trim panel/cover: 3 Nm