Attention! The use of a cable in which at least one thread is torn is unacceptable! This cable needs to be replaced.
Removing
1. With a 10 mm wrench, unscrew the nuts for fastening the cables (the photo shows only the traction cable of the drive, the return cable is removed for clarity).
![](https://motoinstruction.ru/img/honda/1/110629.jpg)
2. We release the cables.
![](https://motoinstruction.ru/img/honda/1/110630.jpg)
3. Using a Phillips screwdriver, unscrew the two screws connecting the halves of the right block of steering switches.
![](https://motoinstruction.ru/img/honda/1/110631.jpg)
4. Disconnect the two halves of the steering switch block.
![](https://motoinstruction.ru/img/honda/1/110632.jpg)
5. We remove the bosses of the throttle control cables from engagement with the control handle.
![](https://motoinstruction.ru/img/honda/1/110633.jpg)
6. With a 14 mm wrench, we loosen the lock nuts of the drive cables and unscrew the threaded parts of the cable sheaths from the body of the steering switch unit.
![](https://motoinstruction.ru/img/honda/1/110634.jpg)
7. Using a 10 mm wrench, unscrew the bolt of the ignition coil bracket and remove the throttle valve drive cables from under it.
![](https://motoinstruction.ru/img/honda/1/110635.jpg)
Lubricate the cables as described in «Control cables - check and lubrication».
Installation
We install the throttle cable in the reverse order. The cables must move smoothly in the shells and without jamming.