Reassembly
- Apply a small quantity of THREAD LOCK to the startor bolt.
- Tighten the generator stator bolts 1, clamp bolt 2 and CKP sensor bolts 3.
- 99000-32050: THREAD LOCK "1342" or equivalent
- Generator stator bolt 1: 11 Nm (1.1 kgf·m, 8.0 lb·ft)
- CKP sensor bolt 3: 6.5 Nm (0.65 kgf·m, 4.5 lb·ft)
Note: Be sure to install the grommet А to the generator cover.
Bearing inspection
- Inspect the starter motor shaft bearing for abnormal noise and smooth rotation while they are in the generator cover.
- Replace the bearing if there is anything unusual.
Bearing removal
- Remove the snap ring 1 and bearing 2.
