Rear suspension construction 1. Rear shock absorber; 2. Rear cushion rod; 3. Spacer; 4. Rear cushion lever bearing; 5. Rear cushion lever; 6. Dust seal; 7. Swingarm pivot bearing; 8. Swingarm; 9. Boot; А. Rear shock absorber mounting nut; В. Rear cushion rod mounting nut; С....
Removal rear suspension Remove the exhaust pipe and muffler. ( 7-8 ) Remove the rear wheel. ( 9-34 ) Remove the final gear case. ( 4-15 ) Remove the under plate 1. Remove the regulator/rectifier 2. Remove the rear shock absorber front mounting bolt and nut. Remove the rear...
Inspection and disassembly rear suspension Spacer Remove the spacers from frame. Remove the spacers from the cushion lever. Remove the spacers from the cushion rod. Inspect the spacers for any flaws or other damage. If any defects are found, replace the spacers with new ones. Frame bearing...
Rear shock absorber disposal Warning: The rear shock absorber unit contains high-pressure nitrogen gas. Mishandling can cause explosion. Keep away from fire and heat. High gas pressure caused by heat can cause an explosion. Release gas pressure before disposing. Gas pressure...
Reassembly rear suspension Reassemble the rear suspension in the reverse order of disassembly and removal. Pay attention to the following points: 1. 1.0 mm (0.04 in); 2. 4.5 mm (0.17 in); А. Rear shock absorber nut; В. Rear cushion lever upper nut; С. Rear cushion lever lower...
Installation rear suspension Remount the swingarm and shock absorber in the reverse order of disassembly and removal, and pay attention to the following points. Cushion rod and cushion lever Install the cushion rods 1 and cushion lever 2 onto the swingarm temporarily. Swingarm...