Starter driven gear inspection
- Turn the starter driven gear by hand.
- Inspect the starter clutch for a smooth movement.
- Check that the gear turns only in one direction.
- Inspect the starter driven gear bushing for any damage. If necessary, replace it with a new one.
Disassembly
- Remove the starter clutch securing bolts.
- Remove the one way clutch 1 and guide 2 from the generator rotor.
Reassembly
- Install the starter clutch in the proper direction.
Note: When installing the one way clutch to the guide, face the flange side ® of the one way clutch to the rotor.
- Apply engine oil to the starter clutch.
- Apply THREAD LOCK SUPER to the bolts, and then tighten them to the specified torque.
- Starter clutch bolt: 25 N·m (2.5 kgf·m, 18.0 lb·ft)
- 99000-32030: THREAD LOCK SUPER "1303" or equivalent