Balancer driven gear inspection
Visually inspect the gear teeth for wear and damage. If they are worn, replace the gear with a new one.
Balancer driven gear disassembly
- Remove the balancer shaft with the special tool.
- 09913-70210: Bearing installer set
- Hold the balancer drivengear with the special tool.
- 09920-53740: Clutch sleeve hub holder
- Remove the balancer driven gear No. 1 bolts 1 and No. 2 bolts 2.
- Remove the spacers 3 and spring washers 4.
- Remove the balancer driven gear No. 1 5 and No. 2 6 from the special tool.
- Remove the springs 7.
Balancer driven gear reassembly
- Set the springs 1 diagonally to the grooves.
- Set the balancer driven gear No. 2 2 to the No. 1.
- Hold the balancer driven gear No. 2 3 with the special tool.
- 09920-53740: Clutch sleeve hub holder
- Turn the balancer driven gear No. 1 4 and align the holes.
- Apply THREAD LOCK SUPER to the bolts (5, 6).
- 99000-32030: THREAD LOCK SUPER "1303" or equivalent
- Tighten the bolts (5, 6) to the specified torque.
Balancer driven gear No. 1 bolt 5:
- 10 Nm (1.0 kgf·m, 7.0 lb·ft)
Balancer driven gear No. 2 bolt 6:
- 25 Nm (2.5 kgf·m, 18.0 lb·ft)
- Set the balancer shaft so that its slit А is aligned with the punch mark В on the balancer driven gear.
- Install the balancer driven gear assembly onto the balancer shaft with the special tool.
- 09913-70210: Bearing installer set (25 mm)