Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
1. If removed, clip the seat lock mechanism and USB socket into the seat lock bracket as noted during removal.
1. Seat lock bracket; 2. Seat lock mechanism; 3. USB socket; 4. Clips
2. Align the seat lock bracket to the seat bridge as noted during removal. Use finger pressure to press the bracket assembly into position on the seat bridge and engage its clips.
1. Seat lock bracket; 2. Seat bridge (underside); 3. Seat lock mechanism; 4. USB socket
3. Position the seat bridge assembly to the motorcycle ensuring that the seat lock cable, USB socket harness and alarm connector block harness are routed as noted during removal. Secure with the four fixings and tighten to 5 Nm.
4. Fit new seat lock fixings and tighten to 5 Nm.
1. Alarm connector block; 2. Seat bridge; 3. Seat lock fixings; 4. Seat bridge fixings
5. Refit the fixings securing the rear undertray to the seat bridge. Tighten to 3 Nm.
1. Rear undertray; 2. Fixing (left hand side shown)
Perform the following operations: