Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
1. If removed, refit the infill panels to both halves of the rear subframe.
2. Assemble the two halves of the rear subframe together using the locating dowel as noted during removal.
![](https://motoinstruction.ru/img/triumph/15/121917.jpg)
1. Locating dowel
3. Secure the two halves of the rear subframe with the bolt and new lock nut. Do not fully tighten at this stage.
![](https://motoinstruction.ru/img/triumph/15/121918.jpg)
1. Bolt; 2. Lock nut
4. Position the rear subframe assembly to the motorcycle and secure as follows:
- Fit the two M10 x 40 bolts to the upper mounting points and secure with new lock nuts.
- Apply a thin smear of copper based grease to the threads of the two M10 x 30 bolts and fit them to the lower mounting points.
![](https://motoinstruction.ru/img/triumph/15/121919.jpg)
1. Upper fixing (left hand side shown); 2. Lower fixing
5. Tighten the rear subframe fixings as follows.
- Holding the lock nut to prevent rotation, tighten the upper mounting bolts to 48 Nm.
- Tighten the lower mounting bolts to 48 Nm.
- Holding the lock nut to prevent rotation, tighten the rear cross member bolt to 30 Nm.
6. Position the evaporative hoses to the rear subframe as noted during removal. Fit the wire guide and tighten its fixing to 7 Nm.
![](https://motoinstruction.ru/img/triumph/15/121920.jpg)
1. Wire guide; 2. Fixing; 3. Evaporative hoses
7. Ensure that the three grommets are fitted to the ABS modulator bracket as noted during removal. Fit the flanged sleeve to the right hand grommet.
8. Fit the seat lock bracket to the ABS modulator bracket, inserting its locating sleeves into the grommets as shown.
![](https://motoinstruction.ru/img/triumph/15/121921.jpg)
1. ABS modulator bracket; 2. Grommets; 3. Flanged sleeve; 4. Seat lock bracket
9. Position the ABS modulator bracket assembly to the rear subframe and secure with new fixings. Tighten the fixings to 9 Nm.
10. Fit the seat lock to its bracket ensuring that the barrel is located into its opening in the rear subframe infill. Tighten the new fixings to 9 Nm.
![](https://motoinstruction.ru/img/triumph/15/121922.jpg)
1. Seat lock; 2. Fixings
Perform the following operations:
- ABS hydraulic modulator/ECM - installation
- Battery tray - installation
- Fall detection switch - installation
- Ambient air pressure sensor - installation
- Evaporative canister - installation
- Seat bridge - installation
- Rear undertray - installation
- Rear direction indicator hanger - installation
- Rear panel - installation
- Rear footrest hangers - installation
- Fuel tank - installation
- Battery - installation
- Seat - installation