Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Perform the following operations:
- Seat - removal
- Battery - removal
- Fuel tank - removal
- Rear footrest hangers - removal
- Rear panel - removal
- Rear direction indicator hanger - removal
- Rear undertray - removal
- Seat bridge - removal
- Evaporative canister - removal
- Ambient air pressure sensor - removal
- Fall detection switch - removal
Note: Note the routing of the seat lock cable and all electrical harnesses for installation.
1. Detach the starter solenoid and main fuse from the fall detection switch bracket.
2. Disconnect the electrical connectors from the starter solenoid.
3. Disconnect the main fuse electrical connector, identified as the white connector located below the fall detection switch mounting.
4. Position the starter solenoid, main fuse and starter leads aside.
5. Release the two fixings and detach the fall detection switch mounting bracket from the battery tray.
![](https://motoinstruction.ru/img/triumph/15/121898.jpg)
1. Fall detection switch bracket; 2. Fixings
6. Detach the two relay clusters from their locating tangs on the battery tray.
![](https://motoinstruction.ru/img/triumph/15/121899.jpg)
1. Relay clusters; 2. Locating tangs
7. Disconnect the ABS modulator multiplug (see ABS electrical connectors).
8. Remove the four fixings securing the rear light bracket to the rear subframe.
![](https://motoinstruction.ru/img/triumph/15/121900.jpg)
1. Rear light mounting bracket; 2. Fixings
9. Remove and discard the fixing and detach the rear brake fluid reservoir from the frame. Ensure the brake fluid reservoir is supported in an upright position. Position the rear brake hose bracket aside.
10. Remove and discard the two fixings securing the underside of the battery tray.
![](https://motoinstruction.ru/img/triumph/15/121901.jpg)
1. Fixing (left hand side shown); 2. Battery tray (underside)
11. Remove and discard the fixing securing the harness conduit and battery tray to the rear subframe. Collect the washer.
![](https://motoinstruction.ru/img/triumph/15/121902.jpg)
1. Rear harness conduit; 2. Battery tray; 3. Fixing
12. Carefully raise the rear harness conduit clear of the rear subframe and position aside.
Note: Note the position of the three remaining battery tray fixings for installation.
13. Remove and discard the remaining three fixings securing the battery tray to the rear subframe. Collect the washers.
![](https://motoinstruction.ru/img/triumph/15/121903.jpg)
1. Battery tray; 2. Fixings
14. Carefully manoeuvre the battery tray upwards through the rear subframe and remove it from the motorcycle.