Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
1. Reconnect the rear light electrical connector.
Note: Route the rear light harness as noted during removal.
2. Position the rear undertray to the motorcycle as follows:
- Locate the front mounting lugs of the rear undertray into the slots on the under side of the battery tray.
- Locate the rear light onto its mounting rubber at the rear of the motorcycle.
- Slide the assembly forwards to fully engage all mountings.
1. Locating lugs; 2. Battery tray slots; 3. Rear light mounting rubber; 4. Rear light
3. Secure the rear undertray with the two fixings and tighten to 3 Nm.
Perform the following operations:
- Rear direction indicator hanger - installation
- Rear panel - installation
- Battery - installation
- Seat - installation
Note: Check the operation of all rear lights. Rectify any faults as necessary.