Check:
- 1. main and signaling system fuses
- 2. battery
- 3. main switch
- 4. wiring (of the entrire signaling system)
Note: Before troubleshooting, remove the following part(-s):
- 1) battery cover
- 2) rider's seat
- 3) fuel tank
- 4) steering head side covers
- 5) headlight lens unit
- 6) tool box cover
- 7) left side cover
- Troubleshoot with the following special tool(-s).
- Pocket tester: 90890-03112
1. Main, ignition and signaling system fuses
Check the main ignition and signaling system fuses for continuity. Refer to "Checking and charging the fuses".
Are the main ignition and signaling system fuses OK?
NO: Replace the fuse(-s).
YES:
2. Battery
Check the condition of the battery. Refer to "Checking the battery".
- Open-circuit voltage: 12.8 V or more at 20°C
Is the battery OK?
NO: Clean the battery terminals. Recharge or replace the battery.
YES:
3. Main switch
Check the main switch for continuity. Refer to "Checking the switches".
Is the main switch OK?
NO: Replace the main switch.
YES:
4. Wiring
Check the entire signaling system's wiring. Refer to "Circuit diagram".
Is the signaling system's wiring properly connected and without defects?
NO: Properly connect or repair the signaling system's wring.
YES: Check the condition of each of the signaling system's circuits. Refer to "Checking the signaling system".